Install Doors; Complete Assembly; Installation Instructions - Gladiator Garageworks PREMIER JUMBO Instrucciones De Ensamble

NOTE: You may need to slightly bend the shelf tabs outward for
the tabs to engage in the slots. Make sure the shelf tabs are in
place behind all the slots, as shown.
A. Cabinet slot
B. Shelf tab
4. Repeat steps 2 and 3 for the remaining two shelves (P5mr). The
magnet for shelves (P5mr) is located on the right-hand side and
facing out, as shown below.
NOTE: Make sure the magnet on the right side of each long shelf
edge is facing out.
P1
A
A. Magnet facing outward
Adjust the Shelves
1. Lift up on the underside of the shelf until the shelf tabs are free of
the cabinet slots.
2. Tilt the shelf up to reposition it within the cabinet or to remove it
from the cabinet.

Install Doors

Phillips-head screw (12)
IMPORTANT:
The door with the lock assembly (P7) should be installed on the
right-hand side of the cabinet.
All manuals and user guides at all-guides.com
A
B
P2
P5mr
P1
P5ml
P5mr
P3
F3c
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are
fastening the screws.
1. Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle four screws through the door hinge into the
cabinet and hand tighten.
P2
P1
P5mr
P5ml
P7
A
P5mr
P3
A. Phillips-head screws
B. Door closure magnets
4. Repeat steps 2 and 3 to attach the left-hand door (P6).
5. Align the doors and completely tighten the door screws.

Complete Assembly

1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling legs. Turn to the
left to raise or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the
door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.

INSTALLATION INSTRUCTIONS

WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT:
Gladiator brand Premier Jumbo cabinet is designed to be
installed on Gladiator ® GearWall
If GearTrack ® channels will be used to support the Gladiator
Premier Jumbo GearBox cabinet, you must use three channels
installed 18" (45.72 cm) apart.
® panels or GearTrack ® channels.
®
5