Publicidad
Idiomas disponibles
Idiomas disponibles
§ Connect the cable from the main PCB to the socket
on the 24V industrial power supply module (1).
§ Connect the two leads from the 24V cable to the
terminal block on the 24V industrial power supply
module (2). When using direct current, make sure
the poles are not switched.
Note:
When using direct current, you can bypass the
built-in rectifier by means of solder bridges (3, 4)
to extend the input voltage range to 24 V~ –10%.
If you do so, make sure you change the current sym-
bol on the manufacturer's ID label from "~" to "-".
$ If necessary, connect the ground lead from the 24V
cable to the 24V industrial power supply module (5).
§ Position the front panel on the display and control
unit and tighten the 4 screws to 1 Nm.
5
Publicidad
