Axxess AX-ADCH02 Instrucciones De Instalación

INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Maintains the retained accessory power (R.A.P.) feature
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains safety chimes
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
† To retain fade in amplified models, use the AX-ADBOX1
APPLICATIONS
See inside front cover
AxxessInterfaces.com
Chrysler Data Interface 2007-up*
*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.
INTRODUCTION
The AX-ADCH02 harness is designed for, and must be used with, the
AX-ADBOX1 or AX-ADBOX2 interface (sold separately). Please refer to the
AX-ADBOX1 or AX-ADBOX2 for the 16-pin connector with stripped leads.
• Can be used in both amplified and non-amplified models
• Retains balance and fade†
• Retains Blind Spot Detection (if equipped)
• Micro "B" USB updatable
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
AX-ADCH02
I N S TA L L AT I O N I N S T R U C T I O N S
TABLE OF CONTENTS
Connections to be made
For models without an amplifier .......................3
For models with an amplifier ............................4
Installing & programming the AX-ADCH02
AX-ADBOX1 ...........................................................5
AX-ADBOX2 ..........................................................6
Adjusting the AX-ADCH02 .....................................7
INTERFACE COMPONENTS
• AX-ADCH02 harness
• 4-pin harness with stripped leads
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun, solder,
and heat shrink • Small flat-blade screwdriver
• Tape • Wire cutter • Zip ties
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
REV. 6/26/18 INSTAX-ADCH02