Publicidad
Idiomas disponibles
Idiomas disponibles
DE2-EAMSAA300 A300 SIREN
INSTALLATION
MOuNTINg
The Armada
A300 siren may be mounted above the dash, below
®
the dash, on a tunnel or in a rack with the mounting bracket and
the hardware supplied. Ease of operation and convenience to the
operator should be the prime consideration when mounting the siren
and controls.
Install the siren on the bracket using the M6x12 bolts and M6 flat
washers & spring washers supplied.
NOTE: Longer bolts will prevent removal of the chassis from the
cover and may damage internal components.
7 POSITION TERMINAL BLOCK CONNECTIONS
+12V - Connect to a positive +12 volt DC source. It is
recommended that the user protect this Wire with a 15 Amp fuse or
circuit breaker located at the source. Use #14 gauge wire.
+12V LTg. - Connect to the positive terminal of the battery with
30 Amp circuit protection. Locate the fuse or circuit breaker at the
battery and use size 10AWG wire minimum.
gRND - Connect to the negative terminal of the battery. This
supplies ground to the siren. Use #14 gauge wire.
LIgHTINg2 - Connect to the load to be controlled by LIGHTING2
switch, it can supply a maximum of 10 Amps.
LIgHTINg1 - Connect to the load to be controlled by LIGHTING1
switch, it can supply a maximum of 10 Amps.
SPKR - Connect to one of the wires from speaker.
COM - Connect to the remaining speaker lead for 100W speaker.
1.800.338.7337 / www.soundoffsignal.com
A
MAX 10
MAX 10
Figure 1 – Wiring Diagram
Air Horn/Manual
Power Indicate
Push Switch
Lamp
YELP
AIR HORN
HI-LO
WAIL
VOLUME
STBY
PHSR
MANUAL
POWER
PA Volume Control&
Rotary Selector Switch
Power Switch
Figure 2 – Control Panel
A
A
12V
BATTERY
15 A.
30 A.
100W SPEAKER
Lighting
Control Switch
LIGHTING1 LIGHTING2
MIC
MODEL A300
Mic Jack
DE2-EAMSAA100 0519 Pg. 2
Publicidad
