Hollywood Racks Baja Rack B2 Instrucciones De Instalación

When using the Hollywood Expedition rack, please follow these important guidelines:
 Install the Baja rack on structurally sound trunks and rear decks only.
 Never attach hooks to aluminum, plastic, glass, fiberglass or carbon fiber.
 Clean the surface of the trunk, rear door or deck lid before installation of the rack.
 Tighten all six straps both before and after mounting bikes on the rack.
 Never place more than 100 lbs. (45 KG) on either B2 or B3
 Always use the attached tie-down safety strap after loading all of the bicycles onto the rack.
This final Safely Strap should be threaded through all of the bikes.
 Keep the bicycle tires at least one foot (1'=30 cm approx.) away from the exhaust pipe(s).
 Check the rack, bikes and straps regularly during use.
 Drive slowly when used on bumpy or dirt surface roads.
Fig.2a
Once the proper rack position has been determined by adjusting
the Baja's bicycle support arms and main frame, tighten the
hubs by flipping black levers in and locking them in place
against the rack; then rotate the lever and/or cup until the
hubs are snug and secure. Be sure that the teeth of the hubs are
interlocked evenly and that the support arms are parallel or pointing
slightly upwards .
Attaching the straps: Begin attaching straps with the upper (farthest
forward) pair, placing the hooks in the most forward trunk lid opening, and
then pulling on the end of the strap until the proper length is reached.
Once the upper straps have been attached, the side and bottom straps
can be attached in any order.
Installation Instructions for Hollywood Racks
Baja Rack B2 (two bike) and B3 (three bike)
bicycle carriers. Comes Fully Assembled
Mounting the Hollywood Baja Rack
After removing your Baja rack from the box, loosen
the black hubs by flipping the hub lever outward
(away from the rack). This will allow the two
sections of the rack frame to move relative to one
another for correct rack placement on your vehicle.
Note how the teeth on the hubs interlock into place.
See Fig. 2a & 2b showing the hub and lever in both
the closed and open positions.
Adjusting the rack frame: Position the Baja rack
on the vehicle such that the bicycle support arms
are parallel to the ground, or angled slightly upward
at the back of the rack. The upper pads should rest
Fig.1
on a steel trunk lid, or rear door. If necessary
(particularly on vans, station wagons and SUV's) the
Fig.2b
upper pads may rest on glass. This is because the
b
weight of the rack and bicycles is support by the
upper straps, and the lower pads. Be careful not to
interfere with rear mounted wiper blade.
1
on Your Vehicle:
support
arms Fig.3
main
frame
r