Play - Bigben TW12CD Instrucciones De Funcionamiento

Sleep Mode
Press and hold the SLEEP button, the display will blink. Press the button repeatedly until the display
shows the minute you want to set. You can set 10 to 90 minutes.
It blinks three times to confirm, and then return to the interface before. If you want to cancel the sleep
mode, press to OFF, after blanking three times, the sleep mode will cancel.

Play

Play a disc
1. Press SOURCE repeatedly to select DISC source.
2. Put on a disc with the printed side facing upward.
3. Play starts automatically, if not, Press
4. Press the VOL+/VOL– to adjust the volume.
Pause / resume play
1. During play, press
2. During play, long press
Skip to a track
For CD:
1. Press / to select another track.
2. Press the VOL+/VOL – to adjust the volume.
For MP3 disc and USB/SD
1. Press / to select a track or a file.
2. Press the VOL+/VOL – to adjust the volume.
Search within a track
1. During play, press and hold
2. Release to resume normal play.
Listening to radio
You can program a maximum of 20 preset radio stations (FM).
1. Press the SOURCE button to select RADIO mode. The unit will be in FM radio mode.
2. Press / to search radio station.
3. Select the desired radio station by pressing the
4. Once you find a station you want to save, press the MEM button on the remote control, "P01" will
be shown on the display, press MEM+/MEM- until the desired memory position number appears
on the display. Press the MEM again to confirm and save the current station.
5. (Auto) Press and hole MEM button, The unit will automatically start and search the frequencies,
all available stations are programmed in the order of waveband reception strength, the first
programmed radio station is broadcast automatically.
ATTENTION: For optimal reception, fully extend and adjust the position on the antenna.
Play from external audio
You can play from an external audio device such as MP3 player through this unit.
Line in Jack (Requires a 3.5mm cable)
1. Connect a 3.5mm cable to the Line jack on top panel. Connect the other end of the 3.5mm cable
to an Mp3 player or other audio device.
2. Press the button to turn the unit on.
3. Press the SOURCE button to switch to Line In mode.
4. Use the controls on the connected device to begin playing audio routed through the unit.
.
to pause/resume play.
/ button to fast forward/fast rewind.
/ .
- EN 7 -
/ button.