Assembly; Assembly Casters To Base; Assembly Of Collector Supports; Assembly The Collector Body With Motor To Support - KNOVA KN CP-1041B Manual Del Usuario

ASSEMBLY

ASSEMBLING CASTERS TO BASE
To assemble, place the base plate upside down and install
the four casters in holes provided and tighten with the screw
driver as shown Fig. 1
ASSEMBLING THE COLLECTOR BODY
WITH MOTOR TO SUPPORT
Attach place the
collector body
to the collector
support and
tighten with
open end
wrench as
shown in
Fig. 3
Fig. 3
ASSEMBLING CASTERS TO BASE
Next, the base plate side up, attach
the three coll support to the base plate
provided and tighten with the screw
driver as shown in Fig. 2
Fig. 2
Fig. 1
ASSEMBLING
THE UPPER
BAG
SUPPORT
4
Install the upper
bag support to
the collector body
hole asshownin
Fig. 4
Fig. 4