DOREL ASIA DA1010BB-1 Manual Del Usuario página 12

TWIN BUNK BED
DA1010BB-1 / DA1010BB-2
STEP 6
Insert slats (L) into remaining holes on the bottom side rails (I and K) on the lower
bunk.
Secure salts (L) to the bottom side rails (I and K) with flat head wood screws (4)
using a Phillips head screw driver (not included).
Repeat step 5 and 6 to attach slats (S and L) to the upper bunk.
NOTE: Slats (S and L) will be placed between two wooden blocks.
NOTE: If you notice that any slats (L) are not perfectly flat, be sure to assemble them
so that slats (L) curves up in the middle and down on the ends.