Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Step 1
Measure the width of the opening and determine number of extensions needed for the gate.
Adding Extensions: remove upper and lower end caps on the gate frame.
NOTE: If it is diff icult to remove, use a flat head screwdriver to pry the end caps on the gate frame out.
Connect the extension bar to both upper and lower extension connectors. Insert extension into gate
frame. Re-insert upper and lower caps into the extension connectors.
1
No extensions
29.8"-32.6"
Step 2
Attach gate stopper to the lower bar on the door frame.
NOTE: Insert gate stopper so the arrow is facing up and stopper knobs slide down.
Step 3
Insert the front latch (K) and the back latch (L) into the bottom of the pet door frame. Firmly connect them
together to lock into place. NOTE: Insert latch so the release button is facing up.
2
I
A
Step 4
Place tension knobs onto spindles, insert spindles into gate.
Step 5
Align and secure with wall cups onto your wall with tape pads or screws.
NOTE: Make sure the bottom of the gate frame remains completely at on the oor.
4
A
B
C
Step 6
Tighten both top and bottom tension knobs inward towards the gate.
To ensure safe installation, continue to tighten tension knobs until the gap between the gate latch and the
gate frame housing is eliminated.
6
1 - 2.75" extension
32.5"-35.4"
5
2 - 2.75" extensions
35.3"-38.1"
3
K
D
C
Page 3
L
C
E
C
E
Publicidad
Tabla de contenido
