Required Tools - Jensen Carbon 65 Manual De Instalación

CARBON Speakers
INTRODUCTION
Welcome to Jensen!
This manual is designed to provide information for the owner,
salesperson and installer. For those of you who want quick
information on how to install this product, please turn to the
Installation Section of this manual. Other information can be
located by using the Table of Contents. We at Jensen have
worked very hard to make sure all the information in this manual is
current. But, as we are constantly finding new ways to improve our
product, this information is subject to change without notice.
Installation .......................................................................Page 3
Specifications ..................................................................Page 5
Warranty..........................................................................Page 6
If, after reading your manual, you still have questions regarding
this product, we recommend that you see your Jensen dealer. If
you need further assistance, you can call us direct at 1-800-323-
4815.
Be sure to have your model number and date of purchase
available when you call. Please read your warranty clearly and
retain your receipt for possible future use.
>>
Preparation
!
Disconnect battery cable from negative ( - ) battery terminal.
WARNING: Check vehicle's owner's manual before
disconnecting the battery. Disconnecting the battery in
some vehicles may require an anti-theft code when
reconnecting. Some vehicles may run rough after
reconnecting the battery and require that the on-board
computer be reset at the dealership. Check with your local
dealer if you are uncertain.
!
Check all safety regulations in your vehicle's owner's manual.
!
To ensure an obstacle-free fit, check and double check
mounting depth of the speakers against available depth, as
well as the location of window mechanics, door handles, and
window handles.
!
If using provided grilles, be sure mounting location is sufficient
distance from door and/or window handles.

Required Tools

The following is a list of tools needed for installation:
!
#2 Philips screwdriver
!
Battery post wrench
!
Hand held drill w/assorted bits
!
Wire strippers
!
Wire crimpers
!
Wire cutters
Since some of these Jensen full range speakers are most often
used as direct replacements for stock speakers, some of the
following instructions will not apply. For custom installations see
your authorized Jensen dealer.
2