HAMPTON BAY BACO Utilice Y Cuide La Guía página 8

Attaching the blades to the motor
Remove all nine motor screws (FF) from the blade holder
(L).
Insert one blade (D) into the slot of the blade holder (L).
Start a motor screw (FF) into the blade holder (L) through
the blade hole. Repeat with the other two screws without
tightening any of them until all screws have been started
into the blade holder (L).
Once all screws are attached, tighten each screw (FF)
securely starting with the center screw. Make sure the
blade (D) is straight.
Repeat these steps for the remaining blades (D) .
Remove the four screws (KK) from the bottom of the light kit
holder (M).
Feed the upper connector plug (N) from the motor (B)
through the center opening of the light plate (E). Secure the
light plate (E) to the light kit holder (M) with the four screws
(KK).
Connect the upper connector plug (N) from the motor to the
connector plug (O) on the underside of the light plate (E). Be
sure the push-in type terminals snap into place.
Remove the two light kit screws (KK) (on opposite side)
from the light plate (E). Connect the blue wire from the light
plate (E) to the black wire from the light kit (F), and the
white wire from the light plate (E) to the white wire from the
light kit (F) simply by joining the connector plugs (P)
together. Be sure the push-in type terminals snap into place.
Raise the light kit (F) against the light plate (E). Align the
keyhole slots in the light kit (F) with the two partially
installed screws on the light plate (E). Turn the light kit (F)
counter-clockwise until the screws are sat in the narrow
end of the keyhole slots. Install the two screws (KK),
removed earlier, back to the light plate (E) through the
remaining holes on the light kit (F). Tighten all four screws.
L
KK
E
KK
F
D
FF
M
N
O
E
P
KK