Manfrotto 523 PRO Guida Rapida página 5

OPERATION
NOTE: Not all function may be available depending on camera working mode e.g. if using Sony camera Memory mode the "Record start/stop" functions
are not working.
Selecting zoom speed limit
Press one of the zoom speed buttons. The zoom mode LED should light below or above the button indicating current zoom speed limit.
Selecting zoom mode
To chose between the progressive and fixed zoom modes, press the zoom speed button – each time you press the button, zoom mode will change from
progressive to fixed and vice versa. The LED will indicate current mode.
Customizing zoom speed buttons
Rotate the zoom wheel and zoom with any speed you prefer. Press the zoom speed limiting button, you want to re-program. While zooming, keep it
pressed for approx. 1 sec, until the LED indicator will light off. The new speed limit will be saved in microcontroller internal flash memory and restored
after each power off.
You may always reset the zoom speed to predefined factory setup (see. Resetting zoom speed buttons).
Custom speed reprogramming may be done practically unlimited number of times (min. 1.000.000,- times).
Resetting zoom speed buttons
Each of three zoom speed buttons, is factory pre-set to following LANC zoom speeds:
• No. 1 zoom speed button – speed no. 1 (slowest available LANC speed)
• No. 2 zoom speed button – speed no. 3
• No. 3 zoom speed button – speed no. 8 (fastest available LANC speed)
You may reset each zoom speed button to factory pre-set: stop zooming (release the zoom knob) and press one of the zoom speed limiting buttons.
Keep it pressed for approx. 1 sec, until the LED indicator will light off. The factory pre-set speed limit will be restored.
Progressive mode zoom
Rotate the knob right (or left, dependent on the zoom direction) to zoom tele. The more angle the knob is rotated the faster zoom speed is. Zoom speed
is limited to the pre-set speed indicated by LED.
Rotate the knob left (or right, dependent on the zoom direction) to zoom wide. The more angle the knob is rotated the faster zoom speed is.
Zoom speed is limited to the pre-set speed indicated by LED.
5