Troubleshooting; Technical Specification - dibea E19 Manual De Instrucciones

How To Use
III. How to charge:
1) When only one indicator light is blinking, please turn off the appliance, put it back to
the charging base, then make sure the plug of the charger has been inserted into the
socket. When charging, the indicate lights will become flashing green.
Note： How to use the wall bracket
1. Hang it on the wall with screws
2. Use 3M stickers to make the bracket glued to the wall, for storing the vacuum cleaner
(make sure the height is the same as the vacuum cleaner itself, totally hanging away
from floor is not acceptable)
Wall
Blinking
Charging port
2) It will have 3 green lights on after fully charged.
IV. How to Maintain the Filter:
1）Pre ss the handle loc ke r to
remove the battery from dust cup.
3）Take out the filter case, then
take out the filter.
6
4-5
hours
2）Separate and remove the top cover
as showed below.
4）Wash the filter case and the
filter by water.

Troubleshooting

5）Please dry the filter and the filter case
completely before assembling back.
7）Put the filter case back to the
dust cup.
※Troubleshooting:
1, Empty the dust cup
2, Check if the dust cup is installed correctly
Suction gets weak 3, Check if the filter case and the filter are installed
correctly
4, Clean the filter
1, Charge the vacuum
Stop working
2, Clean the roller brush and the bearing thoroughly
Battery doesn't hold 1, Check if the plug has been inserted already
a charger 2, Check if the socket is useful

※Technical Specification:

Battery 22.2V/2200mAh
Charging time 4-5 hours
Battery charger input 100-240V ~ 50/60Hz 0.3A
Battery charger
26V 0.45A
output
Working time 35min(low speed), 18min(high speed)
Power 150W
Largest Suction 12KPa(MAX)
6）After drying, assemble the filter
to the case.
8）Assemble the top cover to the
dust cup.
7