General Electric 20451 Manual De Usuario página 12

HANG FAN
.
2
Rotate the canopy to the right (clockwise), continue
turning the canopy until the screws (L) lock into place
on the receptacle bracket j slots.
Note:
You may need to loosen the canopy screws
slightly, if you find it's difficult to lock the screws
into the receptacle bracket j slots.
.
4
Tighten all the 4 canopy mounting screws (L).
ATTACHING THE FAN BLADE
.
1
E
The blade holder decoration (K) is a part which fits
between the blades. Attach a blade holder decoration
(K) to the motor assembly (E), align the red dot label
on the blade holder decoration (K) to red dot on the
motor assembly (E), insert the two protrusions on the
blade holder decoration (K) into the small holes on the
motor assembly (E). Secure with two blade holder
decoration screws (FF). Repeat for the remaining blade
holder decorations (K).
12
Fan Installation
L
L
protrusion
red dot label
K
FF
.
3
Make sure the tab on the mounting bracket socket
is properly seated in the groove in the hanger ball/
downrod assembly (R). This will help to balance the
ceiling fan.
WARNING: Failure to properly seat the tab in the
groove could cause damage to wiring.
.
5
To insert canopy trim ring (c), align the slotted hole on the
canopy trim ring (C) with the mounting bracket push lever,
take both hands and push the canopy trim ring (C) up to
the top of the canopy (B). The canopy trim ring (C) will snap
and lock into place on the canopy (B).
.
2
E
I
Attach the blade (I) and blade support plate (J) to the motor
assembly (E), secure with five blade screws (EE). Tip : Secure
1 screw to the motor assembly (E) to help line up the other
holes in the motor, then secure the blade to the motor with
the remaining 4 screws. Repeat for the remaining blades,
tighten all screws.
R
Tab
Groove
J
EE
B
C