Use And Maintenance; Important Safety Instructions; Fitting Instructions - Diamond MS-320TR Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 7
EN

IMPORTANT SAFETY INSTRUCTIONS

Before using your appliance, read carefully the instructions
contained in this booklet, which furnish important informa-
tion regarding installation, use and maintenance safety. The
booklet must be keeped and delivered to the new user in
case of cession of the machine.
The Manufacturer reserves the right to vary the features
of the product without prior notice. The technical data are
merely indicative.
1.
This appliance is intended exclusively for the use for
which it was created, that is to dry hair by means of a
warm air flow. The Producer would not be considered
responsible for any damage caused by it's improper
use.
2.
After unpacking, make sure that the appliance is com-
plete and shows no signs of visible damage or tamper-
ing.
3.
Keep packing materials, which are potential dangers,
away from children (plastic bags, styrofoam packing
pellets, nails, etc.).
4.
Before inserting the plug make sure that the voltage is
the same as indicated on the device and the line supply
is corresponding to the effective rules.
5.
Do not use in presence of gas, inflammable or explo-
sive liquids or substances.
6.
Some fundamental rules which apply to all electrical de-
vices must be observed when using the appliance:
do not touch the heather with wet hands;
do not handle with bare feet;
do not pull the electric cord or the device itself to
unplug it from the socket; pull the plug directly;
do not let children or incompetent people use de-
vice without supervision.
7.
The appliance is not suited for persons (as well as chil-
dren) physically, mentally, sensory disabled, or with no
experience, unless they have been supervised or direct-
ed by someone responsible of their safety.
8.
Do not bring modifications to the product that compro-
mise the safety.
9.
Keep connections dry.
10.
If the power supply cord is damaged avoid to use it. Let
the Manufacturer, or the After Sale Service, or some
similar qualified person replace it, in order to avoid any
risk.
11.
Disconnect the appliance from the supply line, if you
don't use it for a long time.
12.
Always unplug the appliance before doing any mainte-
nance operation.
13.
Periodically verify the integrity of the appliance. If de-
fects are found, do not use it; call an Authorized After
Sale Service.
14.
In case of malfunction or fault, call an Authorized After
Sale Service, and request original spare parts.

USE AND MAINTENANCE

FITTING INSTRUCTIONS

The hair dryers have been specifically designed for verti-
cal attachment on the wall with the air outlet toward the
bottom.
To attach using screw anchors, proceed as follows:
1.
Make sure that the plug is disconnected.
2.
Loosen screw A (Fig.1).
3.
Extend the two strips below the vent in the direction
shown by the arrow B (Fig.1) and take the body away.
With the dual speed models, during this operation the
air speed control lever may come out of its seat getting
deformed in the process; it this event, set in its posi-
tion again.
4.
Using a Ø5 mm bit, drill holes on the wall, correspond-
ing to the installing points of the appliance's body, and
fasten it using the screw anchors C (Fig.2).
5.
In case of steady connection to the power supply, re-
move the cable and close the hole of the body from
which the cable was getting out, using the provided D
plug.
INSTRUCTIONS FOR USE
Remove the hand held nozzle from the hook and position
it as desired near your hair. The hair dryer comes on auto-
matically. When finished, put the hand held nozzle back
on its hook: appliance will switch off automatically.
With the dual speed models, the power and the speed
can be varied by simply moving the lever on the left side
of the body (position I and II).

In case of steady connection to the wire, a bipo-
lar circuit breaker with contact opening distance
of at least 3 mm must be fitted upstream from
the supply line.
This hairdryer must be installed out of the range
of a person using the bath or the shower.
Disconnect the appliance from the power supply
when not used.
For safety reasons, never attach the device
above bath tubs, wash basins, showers, or other
fittings where there may be water.
Make sure that the wall where you plan to mount
the appliance is solid and free of electrical cables
or water pipes inside.

Publicidad

Tabla de contenido
loading

Tabla de contenido