PowerSmith LASER PLTS07 Manual Del Operario página 6

APPLICATION
VERTICAL APPLICATIONS
1. Attach the Wall Mount Plate to the tool.
2. Turn the tool on.
3. Positon the tool against the wall. Use the Bubble Vial
(3) to level the laser line.
4. Hold the Wall Mount Plate firmly in place against the
wall, and remove the tool from the Wall Mount Plate.
5. Attach the Wall Mount Plate to the wall using a small
screw or an adhesive putty.
6. Re-attach the tool to the Wall Mount Plate.
7. Use the Bubble Vial to properly level the laser line.
NOTE:
To level the tool, the air bubble must be in the
center of the two black lines.
MAINTENANCE
WARNING:
Do not turn the laser on while
cleaning the lens. Serious injury to eyes could result.
• Keep the laser lens clean. A dirty lens will affect the
laser beam operation. Clean the lens with a moist
cotton swab. Clothes with nylon content could scratch
the lens causing the laser to operate incorrectly.
• Clean the tool housing with a moist cotton cloth.
Use only water. Do Not use cleaners, solvents or
compressed air to clean the tool.
• Never immerse or let liquid get inside the tool.
• Dry the tool with a cotton lint free cloth and allow to dry
completely before using or storing the tool.
English
This product is warranted free from defects in material and
workmanship for 2 (Two) years after date of purchase. This
limited warranty does not cover normal wear and tear or
damage from neglect or accident. The original purchaser
is covered by this warranty and it is not transferable. Prior
to returning your product to store location of purchase,
please call the Toll-Free Help Line for possible solutions.
ACCESSORIES INCLUDED IN THIS KIT ARE NOT
COVERED BY THE 2 YEAR WARRANTY.
For questions about this or any other PowerSmith™
product,
Please call Toll-Free:
Or visit our website:
www.
powersmithproducts.com
6
wARRANTY
HELP LINE
888-552-8665.