Publicidad
8
NOTE:
WHEN INSTALLING REPLACEMENT BUBBLER
AND PEDESTAL, TIGHTEN NUT (ITEM 12) ONLY
TO HOLD PARTS SNUG IN POSITION.
DO NOT OVER TIGHTEN.
NOTA:
CUANDO SE INSTALE EL BORBOTEADOR DE
REPUESTO Y EL PEDESTAL, APRIETE LA
TUERCA (ARTICULO 12) SOLAMENTE PARA
SOSTENER LAS PIEZAS EN SU POSICIÓN.
NO APRIETE EMASIADO.
NOTE:
LORSQUE VOUS INSTALLEZ UN NOUVEAU
BARBOTEUR ET SOCLE, RESSERREZ L’ÉCROU
(ARTICLE 12) SEULEMENT SUFFISAMMENT
POUR GARDER LES PIÈCES BIEN EN PLACE.
NE PAS TROP SERRER.
Stream height is factory set at 35 PSI. If supply pressure varies greatly from this, remove
Items 1 & 2 and adjust screw on Item 4. Clockwise adjustment will raise stream and
counter-clockwise adjustment will lower stream. For best adjustment, stream should hit
basin approximately 6-1/2" (165mm) from bubbler.
1
3
5
FD7005*1F
10
9
11
BASIN
ESTANQUE
BASSIN
12
FIG. 3
2
4
6
FIG. 4
PAGE 3
BASIN
ESTANQUE
BASSIN
98034C (Rev. A - 10/04)
Publicidad
