Controls & Operation - MoistAir MA0300 Guía De Uso Y Cuidado

Filling
CAUTION: Disconnect power before filling, cleaning or servicing unit.
Keep grille dry at all times.
1) Remove water bottle and unscrew cap on bottom. Fill bottle with unsoftened
water. Replace cap and tighten securely. Use both hands to carry the bottle to
the base.
NOTE: If only softened water is available, it can be
used; however you will notice a build up of minerals
on the evaporative wick much sooner.
2) While the bottle is removed from the unit, make
sure wick is resting all the way into the water
channel.
3) Return bottle to its upright position using the
handle on the top of the bottle. Set the bottle
in the recessed area with the top of the bottle
flush with the top of the humidifier. When
positioned properly, the valve will open and
water will flow into the water channel.
CAUTION: Do not spill water on fan motor. Electrical components must be
kept dry.
4) We recommend using only EPA registered bacteriostat treatment such as
Essick Air Bacteriostat, Part Number 1970 whenever you refill the humidifier to
eliminate bacterial growth. Add bacteriostat according to the instructions on
the bottle.
5) Plug cord into wall receptacle.
Controls & Operation
The humidifier should be placed at least FOUR inches away from any walls and
away from heat registers. Do not place on soft carpet. Unrestricted airflow into the
unit will result
in the best
efficiency and
performance.
Control Panel
The four-speed
digital control
allows you to
monitor room
humidity and
set target
humidity.
Wick Placement
5