Tabla de contenido
Publicidad
2
Prior to mounting an accessory always remove the battery.
Fitting and removing drill cutters
In addition to screwdriver bits with a hexagonal shaft, this tool can also accommodate drill bits with a
hexagonal shaft.
>
/
d
direction when you wish to change the cutter.
3
Always follow the safety notes and the relevant safety code.
Hold the appliance firmly and press the drill steadily onto the work piece. Do not overload the appliance.
Only use drills with no visible wear. Worn drills will have a bad effect on the functioning of the appliance.
Adjusting the torque
The appliance has 16 different torque settings with which to set the power for driving and removing
screws.
^
adjustment ring by the numbers 1 to 15 and by dots between the figures to define intermediate settings
(16 in total).
z
setting if the motor slips.
4
7
Cordless drill/driver MPCD18VDQF/2 User Manual
by rotating the handgrip.
ment ring to the desired position. The available torque settings are indicated on the
firmly clamped. Rotate the drill chuck in the opposite
as possible when using the screwdriver. Select a higher
GB
Publicidad
Tabla de contenido
