Getting Ready - TECshow BUBBLE MASTER Manual De Usuario

Getting Ready

All products are thoroughly tested at the factory
and shipped in perfect condition. If damage has
occurred during shipping, or if components are
missing, please contact your local dealer immedi-
ately. You package should include:
• One Bubble Master
• One LC-3S line controller
Set up
1. Open the shipping carton and carefully remove
the unit from the shipping carton.
2. Be sure to remove packing material from
around the bubble machine.
3. Set the bubble machine on a dry, flat surface.
4. Fill the bubble fluid to the bubble machine, Do
4. TROUBLESHOOTING
This troubleshooting guide is meant to help solve
simple problems. If a problem occurs, carry out the
steps below in sequence until a solution is found.
Once the unit operates properly, do not carry out
followings steps. If the problem persists, refer ser-
vicing to a qualified technician.
Power Connected but No Bubble Is Blew
1. Check the power supply. Plug the unit into
grounded electric power supply socket with
proper voltage.
2. Check your controller if in correct connection,
test the battery if power enough for wireless
controller.
3. Disconnect bubble machine from electric pow-
er supply. Replace fuse with one of the same
type.
not overfill. Use only high quality fluid.
5. Firmly attach the remote control mechanism to
socket (item D on figure) on the back of the unit.
6. Plug mains power cord from the bubble ma-
chine into appropiate power supply socket.
7. Refer to your controller manual for operation
details (Appendix A, B).
Operation
1. Use bubble switch (C of figure) to switch unit´s
ON/OFF, switch "ON" to blows volumes of bub-
bles to the air, and "OFF" to stop.
2. Use controller LC-3S or RC-3 to operate Bub-
ble Master. Refer to your controller manual for
operation details (Appendix A & B).
| Tecshow Bubble Master
English version
P. 5