Publicidad
Idiomas disponibles
Idiomas disponibles
TR128
Installation Procedure for the individual Vehicle Model
Manufacturer
Vehicle model
Vehicle type
IMPREZA
SUBARU
IMPREZA WRX
FORESTER
Vehicle preparations
Inside of vehicle
Roof
Cover
Loading conditions
Model year
Maximum
Load Capacity
4,5 door
2008 - 2011
140
lbs
5 door
2012 -
(
64
kg)
( Load + Base rack
4,5 door
2008 -
+ Attachments )
2014 -
Cleaning the installation area on the
vehicle
Wipe dirt and oil off the roof and
moldings using diluted mild detergent,
and then dry the wiped area.
*Shaded area in the figure.
●Do not use organic solvents such as thinner or benzene to
clean dirt and oil.
Lifting the cover of the carrier
installation locations
EN-２
3109202TR1282C
EN
Fig-1
Carrier installation locations
Bike
FRONT
3
Front
Rear nut of the vehicle
REAR
Front
Front nut of the vehicle
Fig-2
End of radius curve
Protection sheet
Carrier installation locations
F
L
Spacer
Spacer
-EN
-A
Applying the protection sheets
Apply 2 protection sheets at 4 carrier
installation locations (8 sheets total)
aligning their respective center to the
rear nut on the vehicle at the FRONT
installation locations.
Protection sheet
On the REAR installation locations,
align their respective center to the front
nut on the vehicle. (See Figure 1), and
also place one edge of the protection
sheet along the radius curve of the
roof molding (See Figure 2).
Protection sheet
Protection sheet
Roof molding
Placing the cushion bases
FR
RR
Insert the spacer into the cushion base
installation hole. At the FRONT
installation location, align the hole with
the rear nut of the vehicle.
At the REAR installation locations
RL
align the hole with the front nut of the
vehicle and place it over the cover on
the installation location.
Cushion base
Cover
Cushion base
There are 4 different kinds of cushion bases.
●
Check the punch marks.
Cover
EN-3
-EN
3109202TR1283C
-A
Publicidad
