Aoutside Top Exhaust; Installation Overview; Attach The Mounting Plate To The Wall - Hotpoint RVM1535DMCC Instrucciones De Instalación

Horno microondas para colocar encima de la estufa
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A
OUTSIDE TOP EXHAUST

INSTALLATION OVERVIEW

A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Damper Operation
A4. Mount Microwave Oven
A5. Adjust Exhaust Adaptor
A6. Connect Ductwork
A1.
ATTACH THE MOUNTING
PLATE TO THE WALL
Remove the template from the rear wall. The
mounting plate must be secured to the wall using at
least 3 toggle bolts and one wood screw. The wood
screw must engage a wall stud.
1
Remove the toggle wings from the bolts.
2
Insert the bolts into the mounting plate
through the holes designated to go into drywall
and reattach the toggle wings to
Installation Instructions
" onto each bolt.
3
4
12
(Vertical Duct)
To use toggle bolts:
Spacing for Toggles
More Than Wall
Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
Place the mounting plate against the wall and
3
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening the toggle bolts and the
wood screw(s), check again to be sure that the
mounting plate is level and centered left to right.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4
Tighten all bolts. Pull the plate away from the
wall to help tighten the bolts. Be careful not to
over-torque the toggle bolts.
Bolt End

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido