Sencor SWK 157-NAB1 Serie Manual Del Usuario página 11

Variable Temperature Kettle
SWK 157XXX-NAB1 / SWK 1571BL-NAB1 / SWK 1572RD-NAB1 / SWK 1573CO-NAB1 / SWK 1574BR-NAB1
Note:
The boil water with extended boil time mode can be canceled by pressing button B2 again. The
temperature setting / set water temperature maintenance mode can be canceled at any time by
pressing button B3.
Note:
A sound (beep) is made each time a button is pressed.
Attention:
This variable temperature kettle is not calibrated for scientifi c or laboratory purposes. The actual
water temperature inside the kettle may vary from the temperature shown on the display by ±
9°F (5°C).
Do not turn on the variable temperature kettle if it is empty. Incorrect use of the variable
temperature kettle may negatively affect its service life. If you accidentally turn on the variable
temperature kettle without water, a sound will be made after a short time. The display B1,
the water level mark light A7 and the light of the control buttons will switch off. Remove the
kettle from the base and prior to fi lling it up and starting it again, wait several minutes until the
stainless steel bottom cools down.
5. Before taking the kettle off the base A4 make sure that it is turned off (it is in stand-by mode), or
turn it off manually if it is still running. Turn off the kettle by canceling the set mode according to
the instructions contained in paragraph 4.1–4.5.
Pour the boiled or heated water into a prepared container, cup or mug. If you carry the kettle,
make sure that it remains in a horizontal position, particularly if it is fi lled all the way up to the
maximum mark.
If you wish to remove the lid A1 to refi ll the kettle, fi rst empty all the contents of the kettle so that
you are not scalded by the escaping steam.
6. After you fi nish using the kettle, disconnect the power cord from the el. power socket. Empty the
kettle and allow it to cool down.
Note:
Temperature in degrees Celsius mentioned in brackets is only for comparasion.
CARING FOR YOUR WATER KETTLE
To Clean Water Kettle
1. Always unplug the appliance before cleaning.
2. Do not immerse in water or rinse kettle surface with water.
3. To clean base, simply wipe with a damp cloth. Do not use abrasive detergents. Never rinse or
immerse the base in water. If the base has surface stains or spots, use a stainless steel cleaning
agent.
To Clean Water Filter
1. Grasp fi lter and lift out.
2. Rinse under running water.
3. Place back in the kettle in its original position.
To Decalcify Kettle Interior
Decalcifying is recommended regularly, depending on water hardness in your area.
1. Fill the kettle with water and decalcifi er, according to decalcifi er product instructions.
2. Do not boil, as solution may foam over.
3. When fi nished, rinse kettle thoroughly with fresh water.
2014
EN-11
10/2014