Selv Compliance; Power Cord Connection; Lithium Battery; Battery Pack - Sun Microsystems Sun StorEdge T3 Manual De Instalación

SELV Compliance

Safety status of I/O connections comply to SELV
requirements.

Power Cord Connection

Caution – Sun products are designed to work
with single-phase power systems having a
grounded neutral conductor. To reduce the
risk of electric shock, do not plug Sun
products into any other type of power system.
Contact your facilities manager or a qualified
electrician if you are not sure what type of
power is supplied to your building.
Caution – Not all power cords have the same
current ratings. Household extension cords do
not have overload protection and are not
meant for use with computer systems. Do not
use household extension cords with your Sun
product.
Caution – Your Sun product is shipped with a
grounding type (three-wire) power cord. To
reduce the risk of electric shock, always plug
the cord into a grounded power outlet.
The following caution applies only to devices with a
Standby power switch:
Caution – The power switch of this product
functions as a standby type device only. The
power cord serves as the primary disconnect
device for the system. Be sure to plug the
power cord into a grounded power outlet that
is nearby the system and is readily accessible.
Do not connect the power cord when the
power supply has been removed from the
system chassis.
ii Sun StorEdge T3 and T3+ Array Regulatory and Safety Compliance Manual • August 2001

Lithium Battery

Caution – On the system controller board,
there is a lithium battery molded into the real-
time clock, SGS No. MK48T59Y,
MK48TXXB-XX, MK48T18-XXXPCZ,
M48T59W-XXXPCZ, or MK48T08. Batteries
are not customer replaceable parts. They may
explode if mishandled. Do not dispose of the
battery in fire. Do not disassemble it or
attempt to recharge it.

Battery Pack

Caution – There is a Nickel Metal Hydride
battery in the Sun StorEdge T3 and T3+ array
power and cooling units. Panasonic Model
HHR200SCP. There is danger of explosion if
the battery pack is mishandled or incorrectly
replaced. Replace only with the same type of
Sun Microsystems battery pack. Do not
disassemble it or attempt to recharge it
outside the system. Do not dispose of the
battery in fire. Dispose of the battery properly
in accordance with local regulations.

System Unit Cover

You must remove the cover of your Sun computer system
unit to add cards, memory, or internal storage devices. Be
sure to replace the cover before powering on your computer
system.
Caution – Do not operate Sun products
without the cover in place. Failure to take this
precaution may result in personal injury and
system damage.