Bt Transmitter Mode; Care And Maintenance - oneConcept Discman BT 10033713 Manual Del Usuario

BT TRANSMITTER MODE

Pairing to a BT speaker
The CD player can act as a BT transmitter to a BT speaker. Follow the below steps to con-
nect to a BT speaker and play music from a loaded CD. When the CD player is stopped for
approximately 10 seconds, the power will be Automatically turn off,The user will need to
repeat below connection steps to play in BT mode again:
1. Press and hold the A-B/BT BUTTON to switch to BT Pairing Mode.
2. When CD player is in BT mode, "BT" will be seen flashing on the LCD display. The pair-
ing process could take up to 30 seconds. For best results, stay within 3 ft. of the BT
speaker you are pairing to.
3. When the BT connection is made, the "BT" icon on the LCD display will stop flashing and
turn solid, Your BT speaker should indicate when the connection has been made as well.
Begin playing music on the CD player to hear it on the connected BT speaker. If you
are connected to a BT speaker with a play/pause button and do not hear audio, try
pressing the PLAY/PAUSE
4. When you are finished listening, Press the STOP BUTTON to stop the player.
5. Press and hold the A-B/BT BUTTON to turn off BT transmitter mode.

CARE AND MAINTENANCE

Clean the unit with a soft, damp (never wet) cloth. Solvent or detergent should never be
used.
During CD play, or if the CD fails to play at all, its bottom surface may require cleaning.
Before playing, wipe the disc from the centre outwards with a lint-free soft cleaning cloth.
Attention: Never allow any water or other liquids to get inside the unit while clean-
BUTTON.
ing.
23