Signature Kitchen Suite SKSCF1801P Manual Del Propietário página 33

Ice & Water
Problem
Demand exceeds ice storage
capacity.
House water supply is not
connected, valve is not turned on
fully, or valve is clogged.
Water filter has been exhausted.
Low house water supply pressure.
Icemaker is
not making
Reverse Osmosis filtration system
enough ice.
is used.
Tubing connecting freezer to house
supply valve is kinked.
Doors are opened often or for long
periods of time.
Doors are not closed completely.
The temperature setting for the
freezer is too warm.
Freezer was recently installed or
Icemaker is
icemaker recently connected.
not making
ice
Icemaker not turned on.
Possible Cause
TROUBLESHOOTING
Solutions
The icemaker will produce approximately 70-184 cubes
in a 24 hour period.
Connect the freezer to a cold water supply with adequate
pressure and turn the water shutoff valve fully open. If
the problem persists, it may be necessary to contact a
plumber.
Replacing the water filter is recommended:
Approximately every six months.
When the water filter indicator turns on.
When the water dispenser output decreases.
When the ice cubes are smaller than normal.
The water pressure must be between 20 and 120 psi on
models without a water filter and between 40 and 120 psi
on models with a water filter. If the problem persists, it
may be necessary to contact a plumber.
Reverse osmosis filtration systems can reduce the
water pressure below the minimum amount and result
in icemaker issues. (Refer to the Connecting the Water
Line section.)
The tubing can kink when the freezer is moved during
installation or cleaning resulting in reduced water flow.
Straighten or repair the water supply line and arrange it
to prevent future kinks.
If the doors of the unit are opened often, ambient air
will warm the freezer which will prevent the unit from
maintaining the set temperature. Lowering the freezer
temperature can help, as well as not opening the doors
as frequently.
If the doors are not properly closed, ice production will be
affected. See the "Doors will not close correctly or pop
open" section in Parts & Features Troubleshooting for
more information.
The recommended temperature for the freezer
compartment for normal ice production is 0°F. If the
freezer temperature is warmer, ice production will be
affected.
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker to
begin making ice.
Locate the icemaker ON/OFF and confirm that it is
turned on.
33