Battery Operation - Brigmton BAI-300 Manual De Usuario

connection. In this case you don't need the wireless capabilities of the
transmitter cradle.
For cable operation, use one of the supplied audio cables (see page 1 –
Package Contents).
1. Music output via the audio cable is possible while the headphones are
powered off. To save battery power, press the On/Off button (10) to
power the headphones off.
2. Connect one end of the audio cable to the audio input socket (6) of
your headphones. Connect the other end of the cable to the headphones
output socket of your hi-fi equipment.
If your hi-fi equipment has a 6.3 mm stereo socket, connect the adapter
plug (see page 1 – Package Contents) to the cable. You may also
connect the adapter cable (see page 1 – Package Contents) to the cable
to use any of the Cinch audio outputs of your hi-fi equipment.
With this type of connection, the headphones work as a passive device.
The volume can therefore only be adjusted on the audio source.
Switching to radio reception is not possible during cable operation. If you
want to listen to radio stations, you must first disconnect the connection
cable from the audio input socket (6) of your headphones.

BATTERY OPERATION

You may power both the transmitter cradle and the headphones using
conventional batteries. Batteries are not included in the package.
Remove the batteries when the device is not to be used for a long time.
Respect the environment. Old batteries do not belong in the domestic
waste. They must be handed in to a collection point for waste batteries.
Rechargeable AAA batteries cannot be recharged when inserted into the
device.
POWERING THE HEADPHONES USING BATTERIES
The headphones battery compartment is located in the left earpiece.
1. Power the headphones off. To do this, press the On/Off button (10).
2. Hold the left earpiece with your hand and use the other hand to pull
the ear cushion off the left earpiece. To do this, insert a fingernail into
the slot between the plastic frame of the ear cushion and the earpiece at
the bottom of the headphones (see below).