Kit Preparation - Metra Electronics 95-HDIF Instrucciones De Instalación

From the factory fairing:
1. Remove (2) 5/16" nuts securing each
gauge, then push the gauges thru the
front of the fairing. (Figure A)
2. Remove the rubber grommet from the
clutch cable pass-through hole.
(Figure A)
To the 95-HDIF fairing:
1. Push each of the gauges thru the front
of the fairing, then secure them with the
factory hardware. (Figure B)
2. Insert the rubber grommet into the
clutch cable pass-through hole.
(Figure B)
Continued on the next page
6

KIT PREPARATION

(Figure A)
(Figure B)
|
1.800.221.0932 MetraOnline.com