INSTALLATION INSTRUCTIONS
PURE AIR PLUS
ARTIC HEATER REPLACEMENT KIT
(DQ6015)
L31156
Rev. 11/02
When working on air system components the following
precautions should be observed.
1. Stop engine when working under a vehicle. Always block
the vehicle wheels to prevent a fore or aft roll. Bleeding
off system air pressure may cause the vehicle to roll.
Keep hands away from brake chamber push rods and
brake adjusters; they may apply as system pressure
drops.
2. Never connect or disconnect a hose or line containing air
pressure. It may whip as air escapes. Never remove a
component or a pipe plug unless you are certain all
system air pressure has been exhausted.
3. Never exceed recommended working air pressure and
always wear safety glasses when working with air
pressure. Never look directly into component ports or
direct a pressurized air flow at anyone.
4. Never attempt to disassemble a component until you have
read and understood all recommended procedures. Some
components contain powerful springs and injury can result
if not properly disassembled. Use only proper tools and
observe all precautions pertaining to the use of those tools.
Heater Replacement
Kit Parts
QTY.
QTY.
QTY.
QTY.
QTY.
1
Heater with Connector
1
Shield, Purge Valve
1
Retainer, Shield
3
Screws, Self-Tapping
1
Grease, Conductive
CONTENTS
CONTENTS
CONTENTS
CONTENTS
CONTENTS
DESCRIPTION
DESCRIPTION
DESCRIPTION
DESCRIPTION
DESCRIPTION