Operating; Setting Dial Illumination; Alarms - Vetus BATMON Instrucciones De Instalación Y Manual De Manejo

4 Operating

When the power is switched on the
pointer on the instrument will indicate
the charge condition and on the display
the charge or discharge current will be
displayed.
• Press the right push button repeat-
edly to show the other information
in the display, see the separate sheet
'Operation and Setup'. The pointer
will continue to indicate the battery
capacity.

4.1 Setting dial illumination

• Go to Dimmer Control
eration'.
• Dim the brightness by pressing the
left push button for at least 3 seconds.
• Increase the brightness by pressing
the right push button for at least 3
seconds.
See '7 Setting dial illumination'.
Battery Monitor

4.2 Alarms

In case an alarm condition occurs the
warning symbol will be displayed every
30 seconds.
An audible alarm sounds if a buzzer is
connected. Press one of the push but-
tons to switch off the audible alarm.
See 3.6 Setting alarms, for setting the
alarms.
, see '2 Op-
ENGLISH
17
090433.01