Nolan N-Com mcsII Instrucciones De Uso página 13

Fig. 18
 Position the comfort padding in its housing (see specific instructions provided in the helmet user
manual), hooking the neck roll.
 Position both the comfort cheek pads in their housing (see specific instructions provided in the
helmet user manual) making sure that all the press-studs click.
Note: Carefully check the proper final positioning of the cheek pad, pulling the chinstrap toward the
inside of the helmet and testing the press-studs.
Caution: Make sure that there are no cables sticking out of the helmet and that the loudspeakers are
in their housing.
Caution: Always verify the proper length of the chinstrap and adjust it as necessary, once again
referring to the specific helmet instructions.
Fig. 19
ONLY FOR FULL-FACE HELMETS
 Insert the chin guard (microphone side),
gently placing the microphone in its housing.
Then press down on the red tab until the chin
guard is locked in place on the helmet. (Fig.
18)
 Reposition the protection plate covering the
"N-Com" housing on the shell. First insert the
rear part and then press the front part until
the fastening clasp clicks.
MCS II
13