Monitor Description - golmar ART 4/G2+ Descripción

Description
A
B
C
H
I
J
H
A. Speaker.
B. Function buttons, access and selection of menu
functions.
The function of each button is shown on the monitor
screen with an icon located just above each button
(see "TART 4 G2+" manual, cod. 50122527).
Press to access 'Doctor mode' function (standby monitor):
- With the special code '0441' (Doctor mode) already
entered (see "TART4 G2+" manual, cod. 50122527),
press the button for 5 sec. to activate/ deactivate the
function.
- The push button led
function 'Doctor mode' is activated and it will turn off if
the function is deactivated.
Press to acces the recordings menu (standby monitor):
- The push button led
that a photo/video is pending viewing. Pressing will
access the recordings menu.
Golmar reserves the right to make any modifications without prior notice.
ART /G2+ 4

MONITOR DESCRIPTION

SA
GND
HZ
HZ
BUS
BUS
DIP 1 to 5
SA
Monitor address
DIP 6,7
GND
00 - Master
10 - Slave 1
01 - Slave 2
HZ
11 - Slave 3
DIP 8
HZ
EOL resistor
OFF = 0
BUS ON = 1
BUS
will blink in white color if the
will blink in white color indicating
MADE IN CHINA
C.
Monitor status LED :
Yellow ON: Standby without notification.
Red ON: "Do not disturb" Mode a tivated.
D. 4.3" TFT colour screen.
E. Microphone.
F. Raised dots for the visually impaired people
In call /communication
Above this raised dot is the 'Start/ nd communication'
button.
Above these raised dots is the 'Door opening' button.
G. Micro SD card slot (not included).
Type: MicroSD Class 10 from 4
H. Wall mounting connector fixing (x4).
I. Configuration switches.
J. Installation terminals.
TART /G2+ EN
Rev.0419
D
E
F
H
H
c
.
:
E
GB to 128 GB .
4 QG C od e 5012
G
EN
2752