Installing/Removing Canopy - BOB Gear ALTERRAIN Guia Del Usuario

5. Tighten Through-Axle
While securely holding the nut in
place with one hand, use the hex
wrench provided to fully tighten
the through-axle. Tighten as
secure as possible with your own
strenght against the fork dropout.
Pull on wheel to check that it is
securely installed and does not
wobble.
Check the front wheel before
each use of the stroller to
ensure it is properly secured.
Failure to secure the front
wheel can cause the wheel to
vibrate, wobble, or become
detached from the stroller.
FALL HAZARD - Wheel can
detach and cause tip over. Pull
on the wheel to assure it is
securely attached.
Front Wheel Removal
1. Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 10.
2. Remove Through-Axle
Hold the nut in place and use
the hex wrench to loosen the
through-axle. Then remove the
through-axle from the front wheel
and fork.
ALTERRAIN User Guide
3� Remove Front Wheel
Raise the front wheel a few
inches off ground and tap the
top of the wheel with the palm
of your hand to knock the wheel
out of the front fork.
NOTE: Secure and safely store all
small parts.

Installing/Removing canopy

Canopy Installation
1� Open Canopy Lock
Slide lock open on each
side of the canopy.
Close
Open
7