Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION
______________________________________________
The RF 3-channel remote control is used to control actuators of the RF SYSTEM
series such as:
• 3A output modules,
• 16 A output modules,
• modules for motor control.
A
Green signal
LED
The remote control is provided with a green signal LED (A) and a pair of keys (B) for
each channel (C). Each channel can be associated to a different actuator.
The control functions, as described below, can be triggered by pressing the single
keys.
CONFIGURATION
____________________________________________
All that is required to make the association with an output module is to press one of
the keys of the channel to be combined after having set the output module in learn
configuration.
OPERATION
________________________________________________
The control functions possible from the remote control are determined by the
selection of the operating mode made on the associated actuator:
• in combination with a 3A or 16A output module configured for BISTABLE
operation, for example for normal control of lights: the light is switched on (ON) by
pressing the right-hand key and switched off (OFF) by pressing the left-hand key
of the channel accociated to the module;
• in combination with a 3A or 16A output module configured for MONOSTABLE
operation, for example for controlling a bell, it is possible to use either right or left-
hand key of the channel: the charge is activated when it is pressed and
disactivated when it is released;
• in combination with a 3A or 16A output module configured for TIMED operation,
for example for managing staircase lights, it is possible to use either the right or
left-hand key of the channel: the lights are switched on (ON) when it is pressed.
The lights are switched off (OFF) automatically when the time set on the actuator
has elapsed;
• in combination with an output module for motor control, for example for
controlling roller blinds: the blind is raised by pressing the right-hand key and
lowered by pressing the left-hand key of the channel. The blind is stopped by
pressing any key of the channel when it is in motion.
SIGNALS
______________________________________________________
Transmission of a command
When any key is pressed, a blink of the corresponding green LED shows that a
command has been transmitted.
Batteries discharged
When any key is pressed, five blinks of the green signal LED show that the batteries
are becoming discharged. Transmission of the command is guaranteed in any case.
In this case, the batteries must be replaced as soon as possible.
If there are no light signals when a button is pressed, check that the batteries
are present and fitted correctly, and replace them if necessary.
INSTALLATION
Wall mounting support assembly
B
Keys
C
Channel
Wall mounting
BATTERY REPLACEMENT
Do not dispose of discharged batteries in the environment
TECHNICAL DATA
- Operating temperature
- Radio frequency
- Radio range
- Supply
- Max. dimensions (B x L x H)
______________________________________________
with expansion bolts
3
1
__________________________________
+
–
2x1.5V type AAA alkaline batteries
__________________________________________
ENGLISH
with two-face adhesive tape
2
–
+
-5° +40°C
868 MHz
100 m in a free field
2x1.5V type AAA alkaline batteries
120x45x20 mm
3
Publicidad
