Beeper TPM101 Manual De Uso página 31

5. USE OF THE PRODUCT
D. Connection of the sensors with the display
/!\ By default, the sensors are connected with the display. Thus, this operation is only to realize in case of the replacement of one of the sensors.
Press on the "SET" button 5 times to hear a long beep sound. The system enters then in adjustment mode. Then press on the "SET" button to select which tire you
whant to connect with the sensor, then slacken a little air by the valve of the tire, until you see the value of pressure on the screen. Press on the button "SET" until
you hear a beep sound. Repeat the previous stages to connect the other sensors. Once the adjustments are finished, press on the "SET" button for approximately
3 seconds to leave the adjustment mode. Then, you will hear 2 beep sounds. Note: If there is no operation made during 3 minutes, the system leaves automatically
the adjustment mode.
E. Adjustment of the units of measure (pressure and temperature)
> Press the "SET" button for approximately 3 seconds (until you hear a long beep sound), to enter on the adjustment mode of the unit of pressure. Then press on
the "SET" button to display either PSI or BAR. Then select the unit of pressure that you prefer, then press a long time on the "SET" button, until you hear two beep
sounds.
/!\ The high value of pressure alarm is of 3.3 bars and the low value of pressure alarm is of 1.8 bars.
> To enter on the adjustment mode of the temperature unit, press the "SET" button for 5 times in a row. Then, select the unit of temperature that you prefer (°C
or °F) and than press the "SET" button to confirm your choice.
/!\ The value of temperature alarm is of 70°.
31