Bond TableFire Roxbury Manual Del Usuario página 3

• Transport and store the empty gas cylinders carefully and properly.
• If you see, smell or hear the hiss of escaping gas from the propane cylinder: 1. Disconnect propane
gas cylinder, 2. Do not attempt to correct the problem yourself, 3. Get to your gas supplier and/or the
fire department for help.
• Any guard or other protective device removed for servicing this fire bowl must be replaced prior to
operating this appliance.
• The maximum supply pressure is the 250 psi.
• This appliance is designed for use with a 16.40Z (1Lb) propane gas cylinder (disposable). The
propane cylinder must be constructed and marked in accordance with the specifications for Gas
cylinders of the U.S. Department of Transportation (DOT) or the National Standards of Canada, CAN/
CSA-B339, cylinders, Spheres and Tubes for Transportation of Dangerous Goods;and Commission,as
applicable.
• Cylinders must be stored outdoors in well-ventilated area out of the reach of children.
• Disconnected cylinders must have valve caps tightly installed and must not be stored in a building or
any other enclosed area.
• Do not light or use gas unit if lava rocks are wet. Ensure lava rocks are completely dry before
igniting.
• Pumice stones/lava rocks/LavaGlass™ could hit somebody's face or eyes during initial start of this
unit, so please keep away from the firebowl for the first 20 minutes after it has been ignited.
• During Ignition procedure, one should NEVER get his/her face close to and or above the burner. In
case of the unnoticed flame may suddenly be lit up and causing injury.
• Children should never operate this unit. Children must be supervised while near this unit.
• All installation and repair should be done by a qualified professional. This unit should be
inspected annually and cleaned regularly.
• Children and adults should be alerted to the hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the area of the appliance.
• Clothing or other flammable materials should not be hung from the appliance or placed on or
near the appliance.
• Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
• Installation and repair should be done by a qualified service person. The appliance should be
inspected before use and at least annually by a qualified service person. More frequent cleaning
may be required as necessary. It is imperative that the control compartment, burners and
circulating airways of the appliance are kept clean.
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance. For assistance with repair or replacement of the burner or any other parts, calls Bond
Manufacturing at 1.866.771.2663.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned "OFF" before assembling. Do NOT attempt to assemble without proper tools.
1-866-771-2663 | Page 3