Descargar Imprimir esta página

Steren MOV-119 Manual De Instrucciones página 2

Arrancador para auto compacto y batería de respaldo usb

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTIONS
MOV-119
Before using the product, please read the
Compact car starter and USB
Following instructive.
Backup battery
• DO NOT connect this product to the car battery if it is not
necessary; Could cause damage to the vehicle and the
starter.
• Make sure alligators are in good condition. Clean alligators
before using; Any residue, rust or dirt may cause malfunction.
• Remove alligators from the battery 15 seconds after
starting the car. If this time exceeds, the starter may be
damaged.
• This product is NOT a toy, keep it out of the reach of
children.
• Do not expose the equipment or its accessories to dust,
smoke or steam.
• Do not use or store this equipment in dripping or splashing
places.
• Do not connect alligators together.
Ideal for use in 12-volt cars, gasoline, with 2.0-liter engine.
V0.1
Instruction manual
0917A
CONTENT
PARTS
1. Power button
2. Micro USB Port
3. USB port
4. LED Flashlight
5. Starter output (12 V)
Backup Starter / Battery
USB Cable - Micro USB
Alligators
Multi-connector cable
LOADING MODES
VEHICLE STARTING MODE
Before attempting to use this mode, make sure that the starter is fully
Charge the starter for 6 to 8 hours with the Micro USB - USB cable
charged (4 indicators lit).
(included) with a power adapter or a car charger (not included)
1. Disconnect the positive (red) cable from the
car battery terminal.
2. Connect the red alligator to the
h
positive cable of the car. Connect the
black alligator directly into the negative
terminal of the car battery.
3. Insert the alligators into the
LOAD SCHEME
corresponding starter output, and
press the power button.
4. Start the car. DO NOT attempt to start more than
three times.
5. Once the car has been powered up, disconnect both
alligators.
6. Reconnect the positive cable to the car battery terminal.
LOADING A MOBILE DEVICE
SPECIFICATIONS
Connect the multi-connector cable to the USB port. Depending on
Input: 5 V - - - 1 A
the device you are charging, connect the other end of the cable to
Output: 12 V - - -
your computer, then press the power button and the charge will start
5 V - - - 2,1 A (USB)
automatically.
Internal Battery: 6 000 Ah 12 V
Starter current peak: 200 A
The starter will automatically shut down after about one minute of
inactivity.
LANTERN
1. Press and hold the power button for 3 seconds.
2. Press again to change sequence. The team has three lighting
sequences.

Publicidad

loading