Ves Electric VES2006-R Manual De Instrucciones página 5

DRY BOIL PROTECTION AND OVERHEATING PROTECTION
The appliance has thermal automatic control thermostat for
dry boil protection and for protection against overheating, it
will operate if the appliance is switched on when containing
insufficient water level/ with no water to save the heating ele-
ment. Avoid often switch on of empty appliance or appliance
with water level below acceptable level, as this may lead to
the appliance damage.
If the appliance is switched on by accident when it is
empty, the dry boiling protection will automatically switch
it off. The appliance will cool down when filled with cold
water. Then you can use the appliance in the normal
way.
MAINTENANCE
1. Please put the appliance on a flat heat-resistant surface.
2. Pour desired amount of water into the appliance, please
make sure that the water level is between the maximum
"МАX" and minimum "МIN" marks. Wipe up the outer surface
of the appliance if it is wet.
3. Ensure the cable has been connected and 0/I switch is
at 0 position.
4. Press the switch to I position. The illumination will be on.
5. Water temperature continually will be higher and finally
water will boil. The switch will be automatically plugged to
0 position, illumination will be off and steam drawing from
the appliance will finish.
Note: remember you should close the lid tightly, other-
wise the appliance will not switch off automatically.
6. If you want to boil water because it cooled down just
switch on the appliance again. However, this should not be
4