Installation Instructions; Control Panel - Green DS105138 Instrucciones De Instalación Y Manual De Usuario

3.
INSTALLATION
INSTRUCTIONS
•
Before installing the compressor, check if all components are turned off and
unplugged;
• Check if the system´s voltage is compatible with the product;
• Connect the electric circuit to the vehicle´s electric grid;
• Fix the red cable to the positive pole (+) and the black cable to the negative
pole (-);
•
Proceed with the vacuuming process for an approximate period of 40-60
minutes, due to the compressor contains nitrogen (0,5 kgf/cm²) in order to
carry out leaking tests;
• Inject specific electric compressor oil, POLYESTER
ISO VG 68 (Refill 30mL);
•
Use a 10mm-cable and an 80A (on positive cable)
blade fuse. (Battery cable not included).
Inverter
NOTE:
The total length of the power cable shall
not be longer than 5 meters.
Electric Automotive Compressor 12V Kit with inverter/Command/Cable Module - DS105138
16
Electric Automotive Compressor 24V Kit with inverter/Command/Cable Module - DS105181
+
-
Cable Connection
Compressor
Battery (+)
Red
Battery (-)
Black
Compressor

Control Panel

Thermostat
Cable
1 2 3
4 5 6
7 8 9
Cable Connector on Control Panel
1 Compressor Green
2 Empty
3 Pressure Switch (-) White
4 Blower Motor (PWM) Brown
Battery (+) Red
5
Blower Motor (+) Yellow
6 Empty
7 Auxiliar output 24v Blue
8 Battery (-) Black
9 Empty
Electric Automotive Compressor 12V Kit with inverter/Command/Cable Module - DS105138
Electric Automotive Compressor 24V Kit with inverter/Command/Cable Module - DS105181
1 2 3
4 5 6
7 8 9
Cable Connection
1 Pressure Switch (-) Blue
2 Empty
3 Compressor Gray
4 Empty
5 Battery (+) White
6 Blower Motor (-) Brown
7 Empty
8 Battery (-) Black
9 Empty
Condenser Fan /
Condenser Relay
17