EURO-PRO Shark CORDLESS V1950 Manual Del Usuario página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
Assembling Your Cordless Sweeper
Your cordless sweeper will require very little assembly. You should remove it from
the carton and familiarize yourself with all the components listed per the exploded
view drawing. (Pg. 2) This will help you in the assembly and operation of your
cordless sweeper.
Note:
The charging adapter will be shipped inside the packaging.
1. To assemble your sweeper, push the handle into the base. It will snap into place
firmly. (Fig. 1)
Fig. 1
2. To straighten the handle, simply lift the upper
handle. The forward folding pivot will click into the
straightened position as shown in Figure 2.
3. To fold the handle, press on the handle release
button firmly while bending the handle forward. The
forward folding pivot will click into the bent position
as shown in Figure 3.
Fig. 2
Fig. 3
3
OPERATING INSTRUCTIONS
Charging Instructions
1. Connect the charger plug to the charging jack or hole on the side of the sweeper.
Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger
Kuantech KA12D090015023U. (Fig. 4)
2. This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must
be charged for a minimum 20 hours.
3. When recharging the unit, the "On/Off" switch must be in the "OFF" position.
4. The charging light indicator on the top of the sweeper will illuminate to indicate
that the sweeper is properly charging.
5. To recharge, repeat step #1 above. Charging times will vary depending upon the
amount of usage between charging cycles.
Note:
If, when you place the sweeper to recharge and the charging indicator light does
NOT illuminate, then press the On/Off button once to turn the sweeper off. The
charging indicator light should now light up.
Note:
Peak performance may only be realized after the unit has been charged and
discharged two (2) or three (3) times.
Important:
To maintain peak performance of your cordless sweeper, it is
recommended that the unit be fully discharged, then completely re-charged at least
once a month.
Caution:
Use only the adaptor supplied with the sweeper.
Do not clean the sweeper while unit is charging.
Do not attempt to remove the battery pack from the unit to charge it.
Never attempt to throw the battery pack or unit into a fire or incinerate it.
Do not attempt to remove or damage the battery casing.
Charging
Light
Indicator
Fig. 4
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Shark cordless v1950spShark v1950Shark v1950sp

Tabla de contenido