Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Install 4 C batteries as indicated inside the battery
compartment. (Located on the top of the unit.)
A plug-in power adapter may be purchased separately
and used instead of batteries. Use only an adapter with
an output of 6V 1200mA, center positive.
Push the control bar to rotate the tie rack in the
desired direction. The unit will automatically stop after
20 seconds or press the STOP button to manually
stop rotation.
The light will remain on for a few seconds after the
rotation has stopped. Press the STOP button to turn the
light on for an additional ten seconds.
Mounting on a Clothes Rod
The adapter for mounting to oval clothing rods comes
attached to the mounting bracket. It must be removed
to fit the tie rack on standard and larger clothing rods
(see diagram).
Remove the mounting bracket by sliding it off the tie
rack in the direction indicated by the arrow. (Remove
oval adapter if not required for your closet rod.)
Position the unit under the rod.
Slide the mounting bracket over the rod and back into
place on the tie rack. Confirm that the hooks of the
bracket are firmly engaged with the slots of the tie rack.
4
Quiet Power
Tie Rack
™
Small Diameter Rods
Peel and apply the supplied adhesive rubber strips across
the top and bottom of the clothing rod. Mount as directed
for a standard clothing rod.
Large Rods and Under a Wooden Shelf
If the rod is larger than 1-3/8" the unit can be mounted
directly to the rod by screwing the main bracket onto the
rod. The bracket can also be screwed to the bottom of a
wood shelf if no rod is available.
Use the two screws (provided) to attach the bracket to the
bottom of the rod. (The oval adapter and hole plugs must
be removed first.) Slide the unit firmly onto the mounted
bracket.
Mounting on a Wire Shelf
The tie rack may be installed on a wire shelf, using the
hooks and plastic spacers provided. They are designed to
fit through the holes in the top of the mounting bracket.
Slide a plastic spacer onto each hook. (The spacer should
fit onto the lower bar of the wire shelf.) Refer to diagram.
Slip the mounting hooks into the bracket holes and put a
wing-nut on. (The oval adapter and hole plugs must be
removed first.)
Fit hook and spacer to the wire shelf bars and tighten the
wing-nuts to secure bracket.
Slide the unit securely back onto the mounted bracket.
Publicidad
