Dirty Pro Tools A805 Manual De Instrucciones página 9

USER GUIDE
ASSEMBLY INSTRUCTIONS
MOUNTING THE TABLE ASSEMBLY
1. Locate the Table Support, mounting Hex Screws, Lock Washers and Flat Washers.
2. Set the Worktable on its side and align its mounting holes with the mounting holes on
the Table Support.
3. Attach the Table Support to the Worktable using the Hex Screws, Lock Washers and
Flat Washers.
4. Position the Table Support in the corresponding mounting holes located on the side of
the Base.
5. Place a Flat Washer on the thread of the Knob. Then screw the Knob into the threaded
hole in the Base.
6. Loosen the three Hex Screws and adjust the Worktable so there is a maximum of 2mm
space between the Sandpaper Pad and the Worktable. Then retighten the Hex Screws.
INSTALL THE BACKSTOP
BENCH BELT SANDER
1. Place the Backstop over the Bed and use a
Hex Screw, Lock Washer and Flat Washer to
secure the Backstop to the Bed.
Please Note: The Backstop must not be in
contact with the Sanding Belt
09