DA20DC
➤ Use two people to hook the awning on to the mounting bracket (fig. e,
page 2).
Check whether the awning has been properly hooked and that it is flush
against the wall.
WARNING!
!
Do not open the awning or leave it unattended, before the awning
has been fastened to the mounting bracket.
➤ Fasten the awning to the mounting bracket with the self-tapping bolts
(fig. f, page 2).
➤ Connect the awning electrically (see chapter "Connecting electrical power
to the awning" on page 20).
Contact a qualified electrician to ensure compliance with all legislative
regulations.
➤ Put on the right-hand cap cover (fig. h, page 2).
➤ Push the covers on the backer plates until both lugs are engaged.
➤ Attach the wall bracket for the remote control at a suitable location inside
of the RV and protected against direct sunlight (fig. j, page 2).
EN
Installing the awning
19