HAMPTON BAY 221809 Guía De Uso Y Cuidado página 8

Fasten the blade assemblies (D) to the motor (B) with motor
screws (FF) and lock washers provided. Repeat procedure
for the remaining blade assemblies. Make sure all motor
screws (FF) are tightened securely.
Remove the three light kit screws and washers (KK) from
the side of the switch housing cover on the light kit (F) and
set them aside.
Remove the finial nut (MM), cover plate (NN), hexagon nut
(OO), flat washer (PP), and rubber washer (QQ) from the
light kit (F).
Locate the single blue wire and single white wire from the
switch housing marked "FOR LIGHT KIT CONNECTION".
Connect the blue wire from the switch housing to the black
wire from the light kit, and the white wire from the switch
housing to the white wire from the light kit simply by joining
the connector plugs (RR) together. Be sure the push-in type
terminals snap into place.
Carefully push all wires back into the switch housing.
Secure the light kit (F) onto the switch housing using the
previously-removed light kit screws and washers (KK).
B
D
FF
RR
QQ
PP
OO
NN
MM
KK
F