TMC Aquarium V2Therm 50 Manual De Instrucciones página 3

V
instructions For instAllAtionAnd use
important safety information - please read carefully
- Always isolate the heater from the mains electricity before installing or carrying
out any maintenance.
- Power to the heater must be supplied through a Residual Current Device (RCD) with a
rated residual operating current not exceeding 30mA.
- The heater is designed to run completely submerged in water - do not operate out of water.
- If removing the heater from the aquarium or sump, isolate it from the power supply and wait
approximately 15-20 minutes for it to cool, before removing it.
- Heater rating: 220-240V, 50Hz unless marked otherwise.
- Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or if it
has been dropped or damaged in any way.
- This heater is designed to be used indoors and is not suitable for any outdoor
applications.
- Ensure the heater is securely installed before operating.
- Always leave a drip-loop in the heater cable to prevent water running down
the cable and reaching the power source (see picture below).
- Dispose of this unit responsibly. Check with your local authority for disposal
information.
Product Information
This unit is manufactured and conforms to:-
Safety: BS EN 60335-1:2002. BS EN 60335-2-55:2003
EMC: EN 55014-1:2006. EN 61000-3-2:2006. EN 61000-3-3:1995, EN 55014-2:1997
2
Therm
Drip-loop
Digital Heaters
Aquarium
Typical Installation
1