Publicidad
Idiomas disponibles
Idiomas disponibles
Manual (hold) mode
To use this mode, press the
selected (outlined) on the screen. Then, set the desired
temperature using the
In this mode, any modification to the temperature
setpoint must be done manually.
Economy mode
To use the economy mode, press the
ECONO is selected (outlined) on the screen. This
mode is ideal for weekend residences as it can be
used as follows: The temperature is kept at an
economy level during most of your absence and is
raised to a comfortable level by your usual arrival. If
you do not show up, the temperature returns to the
economy level until next weekend.
The economy mode has two periods which should be set as follows:
Period Temperature Setting
Set to a comfortable
1
level.
Set to an economy
2
level.
The economy mode should be used as follows:
Place the thermostat in economy mode during your absence.
When you arrive, place the thermostat in automatic mode or in
manual mode before the temperature drops back to the
economy level.
When you leave, switch the thermostat back to economy mode.
To program the two periods of the economy mode:
Press the
button until ECONO is selected.
Press the
button. Period 1 is displayed.
Set the start day for the period using the
Set the start time using the
Set the temperature for the period using the
Press
to select period 2.
Repeat steps 3 to 5 to set the day, time and temperature for
period 2.
Press
to return the thermostat to normal display.
Power Outage
During a power outage, the thermostat display remains lit for
approximately the first 15 minutes during which the LP (low power)
indicator appears. The settings are saved in memory. However, if the
power failure exceeds 5 hours, only the thermostat's clock must be
re-adjusted. When power returns, the thermostat returns to the mode
of operation preceding the power outage.
TL6120
button until MAN is
buttons.
button until
Start Time Setting
Set a time where the temperature
starts to rise to reach a comforta-
ble level by the time you arrive.
Set a time where the temperature
starts to drop to an economy level
if you do not show up.
button.
and
buttons.
buttons.
4.
Troubleshooting
PROBLEM
Thermostat is hot.
Wrong temperature is dis-
played.
5.
Wrong time is displayed.
Temperature does not change
according to the programmed
schedule.
The normal display disappears
and reappears after a few min-
utes.
Specifications
Supply: 240 VAC, 50/60 Hz
Minimum load: 500 W (2 A resistive only)
Maximum load: 3000 W (12.5 A resistive only)
Display range: 32°F to 99°F (0°C to 70°C)
Setpoint range: 40°F to 80°F (5°C to 27°C)
Resolution: 1°F (1°C)
Storage: -4°F to 120°F (-20°C to 50°C)
Dimensions: 5.0 x 4.8 x 1.3 inches (126 x 121 x 33 mm)
Approval: c UL us
Warranty
Honeywell warrants this product, excluding battery, to be free from defects in the
workmanship or materials, under normal use and service, for a period of five (5) years
from the date of purchase by the consumer. If at any time during the warranty period the
product is determined to be defective or malfunctions, Honeywell shall repair or replace it
(at Honeywell's option).
If the product is defective,
(i)
return it, with a bill of sale or other dated proof of purchase, to the place from which
you purchased it, or
(ii)
call Honeywell Customer Care at 1-800-468-1502. Customer Care will make the
determination whether the product should be returned to the following address:
Honeywell Return Goods, Dock 4 MN10-3860, 1885 Douglas Dr N, Golden Valley,
MN 55422, or whether a replacement product can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty shall not
apply if it is shown by Honeywell that the defect or malfunction was caused by damage
which occurred while the product was in the possession of a consumer.
Honeywell's sole responsibility shall be to repair or replace the product within the terms
stated above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF
ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES
RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY,
EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some states
do not allow the exclusion or limitation of incidental or consequential damages, so this
limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON
THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, IS HEREBY LIMITED TO THE FIVE-YEAR DURATION OF THIS
WARRANTY. Some states do not allow limitations on how long an implied warranty lasts,
so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may have other rights which vary
from state to state.
If you have any questions concerning this warranty, please write Honeywell Customer
Relations, 1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-468-1502. In
6.
Canada, write Retail Products ON15-02H, Honeywell Limited/Honeywell Limitée, 35
Dynamic Drive, Scarborough, Ontario M1V4Z9.
Customer Assistance
I
f you have any questions about the operation of your thermostat, please go to http://
yourhome.honeywell.com, or call Honeywell Customer Care toll-free at 1-800-468-
1502.
As an E
determined that this product meets the E
guidelines for energy efficiency.
SOLUTIONS
Under normal operation, the thermostat housing
may reach a temperature between 95°F (35°C)
and 104°F (40°C).
Verify that the sticker on the thermostat's screen
has been removed. If the thermostat is exposed to
air draft, eliminate the draft.
The thermostat was probably without power for
more than 5 hours.
Check that the thermostat is in automatic mode.
Check the schedule and clock settings.
The thermal protection device on the heater might
be open. This can happen if the heater is
obstructed by furniture or curtains and has over-
heated.
®
S
partner, Honeywell has
NERGY
TAR
NERGY
69-1908ES
1/16/06
7.
8.
9.
10.
S
TAR
2/2
Publicidad
