Knape & Vogt HyLoft 00540 Instrucciones De Ensamblaje página 4

2. Adjust Support Bar Assemblies (optional)
If necessary, adjust length of Support Bar Assemblies (C) by removing Hex Bolts & Hex Nuts as shown.
Overlap Downrods to the length desired & reinstall Bolts & Nuts, being sure both Support Bar Assemblies
are level.
3. Place and Attach Grids
3A
Lay both 15" Wire Grids (A) on left and right sides
of Support Bar Assemblies (C) and attach as shown,
using 1/4" x 2" Carriage Bolts (E) and 1/4" Flange
Nuts (F). Note: Long grid wires go on the bottom.
E
lled.
ly insta la
if impr oper or asum e toda nte.
kg) or prad rrect ame on.
lbs. (114 El com lado inco ation
eds 250 on liabi lity. insta ad del limit
load exce ation O si está été insta bilid llée
lity if ts for limit s (114 kg). la resp n'a pas onsa bilité .
all liabi men libra n para si l' u nité de resp onsa ing
r assu mes n docu exce de 250 lació kg) ou nts Pend
Purc hase insta llatio el peso tos de la insta s (114 l a limit nal Pate ation
se see ad si men de 250 livre n pour natio
Plea onsa bilid r los docu s excè nt l' i nsta llatio US & Inter
por resp favo si le poid erna 6409 031;
Vea bilité ts conc 105;
onsa men 0353 ; 6435
e la resp les docu ; D47
me tout cons ulter ; D47 7957
eur assu Veui llez ; D45 9926
L' a chet ctem ent. 6152
corre nts: D41
US Pate
F
Sticker (K)
You have now completed the installation and are ready to load your new HyLoft
Storage Unit. (Maximum 250 lbs. per 45" x 45" unit, evenly distributed).
Place the HyLoft Sticker(K) provided on a support bar for easy reference information.
Periodically (at least annually) check all connections to ensure that they remain tightly
fastened.
Installing Two HyLoft 45" x 45" Units:
Follow the instructions above. Multiple units may be joined together by using
Plastic Tie Straps (J) provided.
Page 4
Remove Screws
to Adjust
Downrods to
Desired Length
Four-wire clusters
nearest down-rods
Ceiling Joist
3B
H
Lay 13" Wire Grid (B) on top of Support Bar
Assemblies (C), between the (2) 15" Wire Grids (A),
and bolt together using (2) #6 x 1" Carriage Bolts (G),
#6 Washers (I), and #6 Hex Nuts (H) on each side.
G
I
310491/0917