Hozelock Viton Instrucciones De Montaje página 4

Maintenance • Entretien • Wartung • Onderhoud • Mantenimiento • Underhåll • Vedlikehold • Huolto • Vedligehold
Manutenzione • Manutenção • Konserwacja • Συντήρηση • Bakım • Karbantartás • Zdr ba • Техническое обслуживание
Hooldamine • Tehniskā apkope • Priežiūra • Întreţinere • Обслуговування • Vzdrževanje
23
B
C
D
GB
Thank you for choosing a Hozelock quality sprayer, you can be
assured of many years of reliable service from this product.
Instructions & Warnings
• This sprayer is intended for use with proprietary cleaning,
degreasing, disinfecting and stripping products.
• Always follow the chemical suppliers instructions, as well as
the instructions supplied with this sprayer.
• Make sure all nuts are screwed hand tight before use.
• If the sprayer has been used with chemicals, discard safely
any unused solution after use.
• Always use eye protection when replacing valves, seals or
springs.
• Check with the chemical manufacturer that their product
can be applied using a sprayer.
• Nitric acid, acetic acid and propionic acid must only be used
in a concentration of up to 10%, phosphoric and sulphuric
acid in a concentration of up to 30%, and potassium
hydroxide and caustic soda in a concentration of up to 20%.
• If other products are to be used, ensure they will not be
harmful to the sprayer, people or the environment.
• Upon request, Hozelock will provide you with a list of
materials used in the sprayer's components.
NOT SUITABLE FOR:
• Combustible liquids with a flashpoint below 55° C
• Acids and lyes (for exceptions see above)
• Wetting Agents (tensides)
• Viscous or sticky liquids or liquids that form residues (dyes,
greases)
• Liquid with temperatures above 30° C
• Before carrying out any maintenance on this sprayer
it is essential to depressurize the bottle, by lifting the
pressure release knob.
Always wear protective clothing, goggles, face mask and
gloves.
Avoid inhaling spray mist.
Avoid skin contact with chemicals.
24
I J
A
A
A
Always work in a well ventilated area.
Take care to protect children, pets & fish from exposure to
chemicals.
Always wash hands thoroughly after use & especially
before eating.
Always wash any contaminated clothing.
Seek medical attention if spray gets in your eyes or you
develop any symptoms after spraying.
Do not spray near food or food preparation areas. When
spraying crops, pay particular attention to the chemical
manufacturers advice on time before crops can be eaten.
Do not spray any solvent e.g. White spirit.
Spray only thin watery solutions; thicker mixtures will clog
the nozzle.
Powdered chemicals can be sprayed successfully if they
are completely soluble in water. If they are not, or the
solution tends to settle, spraying can still be successful if
the mixture is continually agitated.
If the material to be sprayed contains sediment, strain the
liquid into the sprayer bottle.
Do not over pressurize the bottle. The pressure release
valve is designed to release excess pressure, and must not
be tampered with, or forced to remain closed.
Do not leave the sprayer pressurised and/or exposed to
direct sunlight. The maximum working temperature of 30°
C must not be exceeded.
Winter use – drain liquid from all parts and loosen pump
assembly.
Annual maintenance – At least once per year thoroughly
clean the whole sprayer and apply silicone grease to all
moving parts & seals. Test with water, and if any washer or
seal has perished it must be replaced.
Ensure the hose fully covers the barbed details on both
A
the lance, and the outlet connection. Make sure all nuts
are hand tight before use.
25
A
Notes
K
B