General Safety Instructions - Stinger NOSQUITO CT100 Manual De Instrucciones

GENERAL SAFETY INSTRUCTIONS

1. WARNING: Read this instruction manual before unpacking and operating the
Mosquito Vacuum and retain for future reference.
2. WARNING: Only use an outdoor extension cord having a 2-prong plug and receptacle
that accepts the Mosquito Vacuum's plug. The trap has a 2-conductor cord and a
2-prong grounding type plug to fit a properly GFCI protected grounded outlet.
3. WARNING: The electrical rating of the extension cord must be greater than or
equal to the electrical rating of the Mosquito Vacuum (120 Volt / 0.8 Amp). Use
an extension cord with 16 gauge or thicker wire and that has a label stating it is
suitable for outdoor use.
4. WARNING: Do not abuse any electrical cord. Never yank the cord to disconnect
from the receptacle. Keep all cords away from heat, flammable substances and
sharp objects. Replace damaged cords.
5. WARNING: The connection between the Mosquito Vacuum and the extension cord
must always remain dry and kept off of the ground.
6. WARNING: Disconnect the Mosquito Vacuum from the power supply when not in
use, changing propane tanks, before servicing and/or cleaning.
7. WARNING: Do not insert foreign objects into this product.
8. WARNING: To avoid electric shock, DO NOT clean the Mosquito Vacuum by
spraying water or by immersing any Mosquito Vacuum part in water.
9. WARNING: All repairs to the Mosquito Vacuum must be performed only by
authorized service personnel.
10. WARNING: Young children should be carefully supervised when they are in the
area of the Mosquito Vacuum.
11. WARNING: Clothing or other flammable materials should not be hung from or
placed on or near the Mosquito Vacuum.
12. WARNING: Any guard or other protective device removed for servicing the
Mosquito Vacuum must be replaced prior to operating.
13. WARNING: A maximum of a 20 lb. LP-Gas cylinder shall be used with the
Mosquito Vacuum.
14. WARNING: Use standard 20 pound LP gas cylinder with a shutoff valve
terminating in an LP-gas supply cylinder valve outlet specified for Connection
No. 791 in the Standard for Compressed Gas Cylinder Valve Outlet and
Inlet Connections, ANSI/CGA-V-1 latest edition (Any standard propane tank
manufactured in the USA after 1999)
15. WARNING: The installation must conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1 for US and with the CAN1-B149 for
Canada. The LP-Gas cylinder used shall be constructed and marked in accordance with
the specifications for LP-Gas cylinders of the U.S. Department of Transportation (DOT).
4