Cooling Fan; Access To Menus - IMS PRO 220E FV CEL Manual Del Usuario

Operating :
• Manual remote control (option ref. 045675)
The remote control enables the variation of current from 50% to 100% of the set intensity. In this configuration, all modes and functions of the
machine are accessible and can be set.
• Pedal (option ref. 045682) :
The pedal control enables variation of the current from the minimum set current to a 100% of the set intensity.
In TIG mode, the machine will only operate in two-stage welding (2T mode). The upslope and downslope are not automatic, and are controlled by
the User with the foot pedal.

COOLING FAN

To minimise sound and dust aspiration, the station integrates a controlled fan system. The fan's rotation speed depends on the temperature and the
machine's settings.
LOCKING CONTROLS
That feature can lock the knobs and keypad to prevent accidental changes in the settings.
Operation :
Press the button for 3 seconds, the display shows
No button is enabled, the secondary knob is disabled, the main knob can adjust the value at +/- of the percentage, defined by the «tolerance» setting
(see chapter «Access to menus»).
To unlock the commands, press the
n°12) switches off.

ACCESS TO MENUS

Output to welding
HMI
Output to welding
HMI
Output to welding
HMI
Output to welding
HMI
Output to welding
HMI
Output to welding
HMI
IMS 220E FV CEL
and goes back to current display. The LED (FIG-2, n°12) switches on.
button for 3 seconds, the display shows
+ x 2s
2s
+
Releasing the buttons
2s
...
2s
...
2s
Valeur
actuelle
Current process
configuration menu
2s
Exiting the
configuration menu
...
2s
Value
current
...
then goes back to current display. The LED (FIG-2,
...
...
...
Available in MMA and TIG LIFT
...
1s 1s 1s
EN
Reminder
+
Output to welding
HMI
Backup
+
Output to welding
HMI
Reminder
+
Output to welding
HMI
Output to welding
HMI
Reset all parameters of all
processes
(except memoirs)
+
Output to welding HMI
23